This S Line spoiler fits the SQ5 as well as the standard Q5, so it's a good match whichever trim you're running. This guide covers fitting our Audi Q5 S Line Rear Roof Spoiler, fitting the Audi Q5 and SQ5, SUV 4x4, 2017 onward.
Tools you'll need
- Isopropyl alcohol (IPA) or a dedicated panel prep wipe
- Microfibre cloths (lint free)
- Masking tape and a tape measure
- Strong automotive adhesive such as Tiger Seal or Gorilla Glue (the supplied 3M tape is for positioning only, not a permanent fix)
- Step stool or access to the roof area
Step 1: Check your fitment
Confirm you have the Q5 or SQ5, SUV 4x4 bodystyle, 2017 onward, before ordering.
Step 2: Clean and prep the surface
Wash the top of the tailgate thoroughly and dry it completely. Wipe the mounting area with isopropyl alcohol to remove all wax, polish and road grime for the strongest possible bond.
Step 3: Mock the position with the supplied tape
Use the supplied 3M tape to hold the spoiler in place temporarily so you can check the line. Measure from the same reference points on both sides so it sits perfectly central.
Step 4: Dry fit before you commit
Step back and check the spoiler sits level from a few angles, including from directly behind the car, before going any further.
Step 5: Bond and secure
Remove the spoiler, apply a bead of strong automotive adhesive to the mounting points, then press it back into your marked position. Apply firm, even pressure along the full width and allow the adhesive to cure fully before driving at speed.
Common mistakes to avoid
- Treating the supplied 3M tape as the final fix rather than a positioning aid
- Not checking clearance around the rear wiper before committing to the final position
- Skipping the IPA wipe down, residue is the top cause of a spoiler lifting
- Fitting in cold weather without warming the adhesive or panel first
- Washing the car or using a jet wash within the first 24 to 48 hours while the adhesive cures
FAQs
Does this fit the SQ5?
Yes, this S Line spoiler fits both the standard Q5 and the SQ5.
Is the supplied tape enough to hold the spoiler permanently?
No, it's there to help you mock the position while fitting. For a permanent fix we recommend a strong automotive adhesive such as Tiger Seal or Gorilla Glue.
Can I fit this myself, or should I get it professionally fitted?
Most owners fit this themselves in under an hour. If you're not confident working with automotive adhesives, we'd always recommend a professional bodyshop or detailer for the best finish.
Browse the full range of car spoilers or shop Audi Q5 parts to find the right fitment for your car.