The MK6 Polo's tailgate spoiler sits along a fairly flat section of roofline, which makes it one of the more straightforward fits in our range, provided you take your time on the positioning. This guide covers fitting our VW Polo MK6 Rear Roof Spoiler, fitting the VW Polo MK6, AW, 2018 onward.
Tools you'll need
- Isopropyl alcohol (IPA) or a dedicated panel prep wipe
- Microfibre cloths (lint free)
- Masking tape and a tape measure
- Strong automotive adhesive such as Tiger Seal or Gorilla Glue (the supplied 3M tape is for positioning only, not a permanent fix)
- Access to the roof area, a step stool or ramp if needed
Step 1: Check your fitment
Confirm you have the MK6 Polo, AW, 2018 onward, before ordering.
Step 2: Clean and prep the surface
Wash the area thoroughly and dry it completely. Wipe the mounting area with isopropyl alcohol to remove all wax, polish and road grime for the strongest possible bond.
Step 3: Mock the position with the supplied tape
Use the supplied 3M tape to hold the spoiler in place temporarily. Measure from the same reference points on both sides so the spoiler sits perfectly central.
Step 4: Dry fit before you commit
Check it sits flush and level within your marked guides before going any further, this is the step that catches alignment issues before anything becomes permanent.
Step 5: Bond and secure
Remove the spoiler, apply a bead of strong automotive adhesive to the mounting points, then press it back into your marked position. Apply firm, even pressure along the full width and allow the adhesive to cure fully before driving at speed.
Common mistakes to avoid
- Treating the supplied 3M tape as the final fix rather than a positioning aid
- Skipping the IPA wipe down, residue is the top cause of a spoiler lifting
- Fitting in cold weather without warming the adhesive or panel first
- Not measuring from matching reference points on both sides, leading to a spoiler that looks slightly off centre
- Washing the car or using a jet wash within the first 24 to 48 hours while the adhesive cures
FAQs
Do I need to drill any holes?
No, this spoiler can be fitted with strong adhesive, most of our customers choose this route over drilling.
Is the supplied tape enough to hold the spoiler permanently?
No, the 3M tape supplied is for mocking the spoiler into position while fitting, not as a permanent fix. We recommend a strong automotive adhesive such as Tiger Seal or Gorilla Glue.
Can I fit this myself, or should I get it professionally fitted?
Most owners fit this themselves in under an hour. If you're not confident working with automotive adhesives, we'd always recommend a professional bodyshop or detailer for the best finish.
Browse the full range of car spoilers or shop VW Polo parts to find the right fitment for your car.