A roof spoiler sits well above eye level on an SUV like the Kodiaq, so getting a level line from the ground is harder than it looks. This guide covers the fitting process for our Skoda Kodiaq Rear Roof Spoiler, available in gloss black for the 2017-2021 generation.
Tools you'll need
- Isopropyl alcohol (IPA) or a dedicated panel prep wipe
- Microfibre cloths (lint free)
- Masking tape and a tape measure
- Automotive grade double sided adhesive tape or panel bonding adhesive (usually supplied with the spoiler)
- Access to the roof area, a step stool or ramp if needed
Step 1: Check your fitment
Confirm you have the 2017-2021 Kodiaq range before ordering, and check the listing against your exact trim.
Step 2: Clean and prep the surface
Wash the roof area above the tailgate glass thoroughly and dry it completely. Wipe the mounting area with isopropyl alcohol to remove all wax, polish and road grime for the strongest possible bond.
Step 3: Mask and mark your position
Use masking tape either side to mark a level line, measuring from the same reference points on both sides so the spoiler sits perfectly central.
Step 4: Dry fit before you commit
Offer the spoiler up without removing the adhesive backing. Check it sits flush and level within your marked guides before going any further, this is the step that catches alignment issues before anything becomes permanent.
Step 5: Bond and secure
Remove the adhesive backing and, working from the centre outward, press the spoiler firmly into place within your marked guides. Apply firm, even pressure along the full width for at least 60 seconds and allow the adhesive to cure fully before driving at speed.
Common mistakes to avoid
- Judging the level line from the ground rather than from directly behind the car, which is easy to get wrong on a tall SUV roofline
- Skipping the IPA wipe down, residue is the top cause of a spoiler lifting
- Fitting in cold weather without warming the adhesive or panel first
- Not measuring from matching reference points on both sides, leading to a spoiler that looks slightly off centre
- Washing the car or using a jet wash within the first 24 to 48 hours while the adhesive cures
FAQs
Do I need to drill any holes?
No, this spoiler is designed as a direct adhesive fit using the supplied tape and adhesive, no drilling is required.
Will fitting affect the rear wiper or high level brake light?
No, it is designed to clear the existing rear wiper and brake light.
Can I fit this myself, or should I get it professionally fitted?
Most owners fit this themselves in under an hour. If you are not confident working with automotive adhesives, we would always recommend a professional bodyshop or detailer for the best finish.
Browse the full range of car spoilers or shop Skoda Kodiaq parts to find the right fitment for your car.