The first generation Juke's raised tailgate glass line makes a natural guide to work from, but its unusual rear styling means it is worth taking extra care with symmetry. This guide covers the fitting process for our Nissan Juke Rear Roof Spoiler Lip Wing, fitting the 2011-2017 first generation.
Tools you'll need
- Isopropyl alcohol (IPA) or a dedicated panel prep wipe
- Microfibre cloths (lint free)
- Masking tape and a tape measure
- Automotive grade double sided adhesive tape or panel bonding adhesive (usually supplied with the spoiler)
- Access to the roof area, a step stool or ramp if needed
Step 1: Check your fitment
Confirm you have the 2011-2017 first generation Juke before ordering, check the listing to confirm against your exact model year.
Step 2: Clean and prep the surface
Wash the roof area above the tailgate glass thoroughly and dry it completely. Wipe the mounting area with isopropyl alcohol to remove all wax, polish and road grime for the strongest possible bond.
Step 3: Mask and mark your position
Use masking tape either side to mark a level line, measuring from the same reference points on both sides so the spoiler sits perfectly central.
Step 4: Dry fit before you commit
Offer the spoiler up without removing the adhesive backing. Check it sits flush and level within your marked guides before going any further, this is the step that catches alignment issues before anything becomes permanent.
Step 5: Bond and secure
Remove the adhesive backing and, working from the centre outward, press the spoiler firmly into place within your marked guides. Apply firm, even pressure along the full width for at least 60 seconds and allow the adhesive to cure fully before driving at speed.
Common mistakes to avoid
- Rushing the marking stage given the Juke's unusual rear styling, small asymmetry is more noticeable here than on a plainer roofline
- Skipping the IPA wipe down, residue is the top cause of a spoiler lifting
- Fitting in cold weather without warming the adhesive or panel first
- Not measuring from matching reference points on both sides, leading to a spoiler that looks slightly off centre
- Washing the car or using a jet wash within the first 24 to 48 hours while the adhesive cures
FAQs
Do I need to drill any holes?
No, this spoiler is designed as a direct adhesive fit using the supplied tape and adhesive, no drilling is required.
Will it affect tailgate operation or rear visibility?
No, it is designed to clear tailgate operation and will not obstruct rear visibility once correctly positioned.
Can I fit this myself, or should I get it professionally fitted?
Most owners fit this themselves in under an hour. If you are not confident working with automotive adhesives, we would always recommend a professional bodyshop or detailer for the best finish.
Browse the full range of car spoilers or shop Nissan Juke parts to find the right fitment for your car.